Extra Adjustable Taxi Licence No-Drill Bracket from MOGO, Suitable for a Square Licence Plate (240 x 176mm) or a Small Licence Plate (240 x 125mm) on a vehicle that requires clearance of between 90mm and 140mm to stop the plate touching the bodywork.

Now a firm favourite with the Taxi trade, the MOGO no-drill bracket systems allow the Taxi trade to fix any licence plate to any vehicle with no drilling, in just a couple of minutes.

Remove the registration plate by undoing the existing screws, place the MOGO bracket behind the registration plate and replace the screws - it's that easy! Add in the included sticky pads if required.

This Taxi Plate Holder/Bracket is designed for vehicles with significant depth changes in the bodywork at the rear, where bumpers or bodywork protrude out significantly near the registration plate, commonly required on larger vehicles and minibuses.

MOGO No-Drill Taxi Plate Holder/Bracket are supplied with FS-1 fixing kit which includes 4 secure locking pins, 2 sticky pads, and fitting instructions. Cable tie packs are also available to purchase separately to use on non-standard fitments.

MOGO No-Drill Taxi Plate Holder/Bracket are usually mounted to display the licence plates below the registration plates, but can also be fitted the other way up to display the licence plates above the registration plate.