The ‘Rear Taxi Plate Holder/Bracket - For Square or Small Licence Plates – Adjustable’ Taxi Licence No-Drill Bracket from MOGO, is used for fitting a Square Licence Plate (240 x 176mm) or a Small Licence Plate (240 x 125mm) on a vehicle that requires clearance of between 55mm and 80mm to stop the plate touching the bodywork.

Now a firm favourite with the Taxi trade, the MOGO no-drill bracket systems allow the Taxi trade to fix any licence plate to any vehicle with no drilling, in just a couple of minutes.

Remove the registration plate by undoing the existing screws, place the MOGO bracket behind the registration plate and replace the screws - it's that easy! Add in the included sticky pads if required.

This Taxi Plate Holder/Bracket is designed for vehicles with a recessed registration plate or where bumpers or bodywork protrude out near the registration plate. If you require more than the maximum clearance listed here the Extra-Adjustable version is available.

MOGO No-Drill Taxi Plate Holder/Brackets are supplied with FS-1 fixing kit which includes 4 secure locking pins, 2 sticky pads, and fitting instructions. Cable tie packs are also available to purchase separately to use on non-standard fitments.

MOGO No-Drill Taxi Plate Holder/Bracket are usually mounted to display the licence plates below the registration plates, but can also be fitted the other way up to display the licence plates above the registration plate.